ed4

Hey gang,

I'm looking to pick up a set of RAD, KICS or another recommended wheel lock for my aftermarket wheels (ADV-1 & Challenge Motorwerks).

Can I reuse my stock bolts with my aftermarket wheels, or will I need to get another set (longer, shorter, etc.)?

I believe that the stock bolts are a ball-seat bolt, as are the bolt holes for my new wheels. What are the type of bolt I need to get (thread pitch and shank length).

Thanks in advance,
Ed

Girard@ACGautomotive

Hey Ed,

Sent you a PM, just need to know if the new wheels are cone or ball seat and we can get you a set!

Let me know.

ed4

Tal,

I tried sending you a PM, but it appears that your inbox is full, which doesn't surprise me, given the amount of stuff you must get on a daily basis

They're a ball seat. I just test fitted my 5.01 SL's and it appears that the stock hardware works well with my wheels, especially the bolt length FWIW.

-ed

Girard@ACGautomotive

Sorry about that Ed.

Sent you a PM. Have everything you need in stock.

Thanks!

ed4

Thanks Tal - can't wait to get them by the end of the week

Roswell

There is a guy selling a nice black set ball seated for our C63 in the classified.. Cheap too.

Rsquad911

If the ADVs were made for your car they should have been drilled ball seat and accept your factory bolts.

I know mine did.

ed4

See post #3