Shut of solonoid
#1
MBWorld Fanatic!
Thread Starter
Shut of solonoid
Ok, I rebuilt my front valve block, and the side that was dropping is fine. But.....
When cleaning the "good" shut off solonoid it dropped the plunger, and of course I was outside blowing it off with my air hose when I learned that it can come out and fall in the gravel you are standing on. Needless to say, now that side drops. I have taken that valve back out twice and replaced the o-rings, and both times they looked perfect, and it still drops at the same rate. I believe i ruined the plunger itself with the falling in gravel and subsequent cleaning in my solvent tank.
I saw a post here a while back where there was a part # for the shut off solonoid, but I can't seem to find it. Anyone know where that thread is or better yet the part # and a source for it?
Thanks, Matt.
When cleaning the "good" shut off solonoid it dropped the plunger, and of course I was outside blowing it off with my air hose when I learned that it can come out and fall in the gravel you are standing on. Needless to say, now that side drops. I have taken that valve back out twice and replaced the o-rings, and both times they looked perfect, and it still drops at the same rate. I believe i ruined the plunger itself with the falling in gravel and subsequent cleaning in my solvent tank.
I saw a post here a while back where there was a part # for the shut off solonoid, but I can't seem to find it. Anyone know where that thread is or better yet the part # and a source for it?
Thanks, Matt.