hd3singh

Hi all , I have a 2010 e250 coupe amg/sport .
Im new to the forum & needed some advice. i noticed loads of posts about offsets & wheels but nothing 100% with so many differant options & opinions its left me confused.. i have checked the brabus chart aswell but this size/offset is not on there

I really like the 3sdm 0.06 alloys that come in 19x8.5 et35 & 19x10 et35 will they fit in this size or would i need to have my arches rolled? & what size tyres would i need?

They allso come in 19x8.5 et42 would this be better all round?..

I want them for the concave look they have but fear if i put 8.5j on they might be flat but not sure how or if the offset will affect it in looks & deepness any ideas?

(im loving the white cab with red 3sdm's on but 0.06 come slightly differant size hence asking)

Draz

I would recommend 19x8.5 et35 for the front, but 19x10 et35 would not fit the rear... it would rub, you would have to roll the fenders... a lot... about 20mm.
The other option, 19x8.5 et42, isn't going to work at all... too shallow for the front, you'd have to use spacer to bring it to et35 or so, and in the rear the 8.5 width is too narrow in my opinion.

hd3singh

Thanks for the reply.... will have to start looking again now

Dr-Nab

Thanks

The 19x10 ET35 won't fit well at all in my opinion, maybe if it was ET45 know there are a few guys running 19x10 on here but I'm sure the offset was pretty high.

You'll be alright with the 8.5 all round ET42 (Carlsson Revo1/5's in 19" are 8.5 wide all round with staggered offsets), maybe drop a 5 or 10mm spacer on all round to get it pushed out to be flush, offset doesn't affect the width or how concave the rims are.

I'm running 8.5 & ET40 up front and 9.5 & ET42 at the back, fit very well but putting a spacer on the fronts 5 or 10mm not sure yet but I'm sat lower so with camber in it makes the fronts look a little too far in the arch for my liking.

The 0.06 is a nice rim, I had considered them initially but the stock was virtually non existent,3SDM have effectively abandoned the UK market just leaving skeleton stock levels to the suppliers here but focus on the rest of the world. Good luck getting in touch with them if you have any queries!

The finish of the rims - over here they won't last a week without rotting through so might want to consider refinishing them or something like clear plasti dip over them to protect them, even the centre caps mine started to rot so I sanded them back and plasti dipped them white.

Not sure who you've sourced/are sourcing the wheels from but Matt @ StancedUK is a top guy to deal with I'd 100% recommend him to anyone.