Finally slammed the bich (pics)
#1
Member
Thread Starter
Join Date: Jan 2013
Location: Wellington, New Zealand
Posts: 75
Likes: 0
Received 1 Like
on
1 Post
1995 Mercedes E320 sedan
Finally slammed the bich (pics)
After being absent from the forum for around 2 years i decided to post a pic of my car after i lowered it. Unfortunatelly it seems to sit about 8mm lower in the front right, it was like this before lowering also. Anybody got any suggestions as to what could be causing this? Or had the same problem?
Bad quality phne pic
Bad quality phne pic
#3
Member
Thread Starter
Join Date: Jan 2013
Location: Wellington, New Zealand
Posts: 75
Likes: 0
Received 1 Like
on
1 Post
1995 Mercedes E320 sedan
I am not running pads at all, these are a new zealand made spring which is made to be run without the pad, even before lowering it sat lower in to one corner
#4
MBWorld Fanatic!
Mine was like that too. Sat about 4-5mm lower on the passenger side. My solution was to get divorced and get a skinnier girlfriend.
Nah jk, I just got coilovers and adjusted it later. Id use a small spring pad if you can...but id be kinda worried about one side sagging that much...is your perch ok?
Nah jk, I just got coilovers and adjusted it later. Id use a small spring pad if you can...but id be kinda worried about one side sagging that much...is your perch ok?
#7
Member
Join Date: Jul 2013
Location: Salt Lake City, Utah
Posts: 179
Likes: 0
Received 8 Likes
on
8 Posts
2012 C250 Coupe, 2017 C43 AMG Coupe
Mine was like that too. Sat about 4-5mm lower on the passenger side. My solution was to get divorced and get a skinnier girlfriend.
Nah jk, I just got coilovers and adjusted it later. Id use a small spring pad if you can...but id be kinda worried about one side sagging that much...is your perch ok?
Nah jk, I just got coilovers and adjusted it later. Id use a small spring pad if you can...but id be kinda worried about one side sagging that much...is your perch ok?