Help with 2012 ML350 Bluetec Upper Limit Reached
#1
Newbie
Thread Starter
Join Date: Nov 2016
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
ML350 BLUETEC
Help with 2012 ML350 Bluetec Upper Limit Reached
PULLING CODE P010 with genetic OBII scanner.
PULLING CODE 150300 code with Snap-On scanner (Hot Film Upper Limit Reached)
Replaced: Both MAF sensors along with gasket, MAP sensor, both air filter. All OEM part. Re-adapt both sensors with Snap-On Scanner.
Vehicle is running great. However I can't clear the check engine light. It's still show the same code.
Please help if you have/had similar problem or experience with it.
Thanks in advance.
Ledvu1
PULLING CODE 150300 code with Snap-On scanner (Hot Film Upper Limit Reached)
Replaced: Both MAF sensors along with gasket, MAP sensor, both air filter. All OEM part. Re-adapt both sensors with Snap-On Scanner.
Vehicle is running great. However I can't clear the check engine light. It's still show the same code.
Please help if you have/had similar problem or experience with it.
Thanks in advance.
Ledvu1
#4
Newbie
Thread Starter
Join Date: Nov 2016
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
ML350 BLUETEC
Problem solved: new Bosch MAP sensor was out of range, didn't produce enough boost pressure. Replaced to DC sensor (O.E brand) on my vehicle, light went away right after.
Good luck,
Good luck,