W221 front left bumper pulled out *pics* , any ideas?
#1
Member
Thread Starter
Join Date: Jun 2012
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
range rover
W221 front left bumper pulled out *pics* , any ideas?
Anyone know if this can be pushed back in or is this a costly repair? Happens when the car was parked over one of those parking blocks.
#2
Newbie
Join Date: Dec 2014
Posts: 8
Received 0 Likes
on
0 Posts
2016 E350 Wagon, 2013 S550 4Matic, 1985 280SL, 2005 Land Rover LR3
It should be a fairly simple repair. I did the same thing- parked over one of those curbs held in place by a spike, the car settled so the tip of the spike caught the bumper. Like a dumbass, I didn't stop when I heard a scrape. My mishap looked worse. The entire right side if the bumper was hanging off the car, all but the two left sensors were pulled off. Took it to the dealer, got referred to the body shop in case I needed to make an insurance claim. Body shop manager said let me get a tech to look at it. About 20 minutes later it was fixed. They just had to contact cement a couple of the sensor mounts back in place and snap it back in all the correct locations. I went to pay and he said "No charge". Made my day.
#5
Newbie
Join Date: Dec 2014
Posts: 8
Received 0 Likes
on
0 Posts
2016 E350 Wagon, 2013 S550 4Matic, 1985 280SL, 2005 Land Rover LR3
Sorry again, (now I'm off the tablet). The bumper flexes and then slide into the lock position. I couldn't get it right because there were other locations along the bottom the were unspapped as well. After the whole experience the design makes sense to me- let the bumper flex enough that it comes loose without ripping any of the fasteners or bending any metal. Needless to say, I learned my lesson to be careful where I park.