compatability question
#1
MBWorld Fanatic!
Thread Starter
Join Date: Sep 2008
Location: murfreesboro,tn
Posts: 3,152
Likes: 0
Received 0 Likes
on
0 Posts
2003 porsche 996 turbo
compatability question
is the crankshaft diameter at the end were the crank pulley goes the same for the m113 and the m112?
basically can i run a m113k crank pulley on my m112k engine? seems you have simialr sizes as we run but cost is much less! something in the way of a 178 or 180 crank pulley to run stacked with my 65mm s/c pulley
basically can i run a m113k crank pulley on my m112k engine? seems you have simialr sizes as we run but cost is much less! something in the way of a 178 or 180 crank pulley to run stacked with my 65mm s/c pulley
#2
Former Vendor of MBWorld
iTrader: (1)
Join Date: May 2008
Location: Houston
Posts: 12,139
Received 292 Likes
on
241 Posts
2003 W211 E55, 2003 W220 S600
I can measure the pulley hole and the key way and report back. But what about the offset and spacing off the rings. I have a damaged asp pulley that you can look at.
#5
MBWorld Fanatic!
Thread Starter
Join Date: Sep 2008
Location: murfreesboro,tn
Posts: 3,152
Likes: 0
Received 0 Likes
on
0 Posts
2003 porsche 996 turbo
#7
MBWorld Fanatic!
Thread Starter
Join Date: Sep 2008
Location: murfreesboro,tn
Posts: 3,152
Likes: 0
Received 0 Likes
on
0 Posts
2003 porsche 996 turbo
you are correct. i was looking at pulley pics and not seeing the smaller rib setup under the larger ring. of course if i can get it to line up its not mandatory to run two belts.