Rubber Molding Replacement
 

Hello everyone. So I want to replace the rubber molding that sits between the body fenders and the bottom trim. I have attached a photo of an example. Where can I pick up those pieces? I am hoping to buy an entire body set and replace them all since they are 20 years old.

Thank you!https://cimg9.ibsrv.net/gimg/www.mbw...5e8f1d70ea.jpg

https://cimg1.ibsrv.net/gimg/www.mbw...2bd876d848.png
I believe these are the part #s
Front seals -
A 202 698 41 30
A 202 698 42 30
Rear seals -
A 202 698 45 30
A 202 698 46 30

Thank you! I posted a reply to your mention on the other forum too.

From the looks of the diagram I would need to take off the bottom molding to then reinsert the new rubber backing... :( I was hoping it was more just install new ones by pushing in the rubber from the outside.