Licence plate light removal
I have purchased a pair of LED licence plate lights, not just the bulbs and need to remove the ones which are on the car at the moment' Has anyone actually manage to take these out?
I have tried it removing the trunk lining and have pressed the clip in on the light but does the light come out through the trunk side or the outside?
Cheers
Trending Topics
I have tried it removing the trunk lining and have pressed the clip in on the light but does the light come out through the trunk side or the outside?
Cheers
The Best of Mercedes & AMG
When i tried on Saturday i got as far as starting to remove the trim behind the licence plate, but wanted to double check that i was doing it the right way and will try again in the next couple of days weather permitting.
When i tried on Saturday i got as far as starting to remove the trim behind the licence plate, but wanted to double check that i was doing it the right way and will try again in the next couple of days weather permitting.

The lens holds the bulb, and is removable by the two stainless short through large course screws. It is PN A203 820 00 66...I know because I replaced both bulbs last night. You use a soft hook tool (Or I am sure a small flat blade screw driver / small hook) and pull off the lens once the screws are out. Once you are holding the lens, you are holding the bulbs, swap and go.
This is the second time I replaced the bulbs, after the first replacement, I added silicone lubricant to the landing area in the trunk lid, this helped removal last night, while adding a tighter water seal than the little gasket on the lens.
Hope this helps.




