nearly :(
|
Tighten the beast down!!! Did you make a good run??
#'s???? |
Great result. Did weistec post this on instagram?
Is that on pump? With which pulley? |
^^^ thats on pump 67mm
this is on 60mm with ms109 |
650whp sweeeeeeet
Engine's moving around a lot. Have you considered strapping it down? Used to use motorcycle ratcheting tie-downs for that. |
i never thought about it to be honest
|
Putting down some serious power :)
|
What is the power difference between the two pulleys?
Do you have two Ecus or did you let the 67mm tune adapt to the 60mm? |
the power difference is night and day
but i custom tuned the 60mm pulley tune THe weistec bench tune is very safe and you will have no issues running the 60mm pulley on there base tune NO i have 2 ecus both custom tuned now i could of went more on the 60mm pulley tune but i wanted it safe i had another 3 degress timing to go my fuel pumps are also maxed now so i didnt want to risk damages its plenty now Its a whole different animal its scary 50whp gain from the change of pulleys but un-tuned its will be more like 20whp on bench tune |
Is your engine internals still stock? Steve told me when I bought the smaller pulley to just put it on and run face fuel, to let the tune adapt.
|
yes stock except for head studs
put it on bud its safe just run straight ms109 The bench tune is safe only 15 degrees timing mines up to 18 degrees now you will be safe |
What's the timing on the bench 67mm tune? That's what I will be using and just letting it adapt. Isn't timing 20-21?
|
I have to double check mate leave it with me
|
that thing is moving brother! looking good!
|
Go get some 9's!!! |
All times are GMT -4. The time now is 09:00 AM. |
© 2024 MH Sub I, LLC dba Internet Brands