Airmatic level one side lower
Hi everybody, after replacing the shocks before, I have a difference in level between the left side and the right side after an automatic calibration with sd conect 5 succeeded.
Thanks |
SD connect 5 autocalibrates? Using an older system, I had to set it manually using an inclinometer on the front control arms and the rear axles. Absolutely level floor, front control arms equal to each other and between 3.1* to 4.1* (inboard higher than outboard) plus rear axles between -0.9* and -1.5* (outboard higher than inboard). Set inclination angles, ensure sensor voltage values within allowable range, confirm inclination angles, go to next screen, enter recorded inclination angles, press "calibrate".
Potential causes: -car not absolutely level prior to calibration, -front control arms not equal inclination angle, -rear bolts were tightened in such a way that one side is binding, -front control arm bolts tightened so that one side is binding. Those are the ones off the top of my head. |
Hi bbirdwell,
Thank you very much for your precious response, I didn't think about that. I'm going to look in this direction Thanks a lot |
All times are GMT -4. The time now is 01:51 PM. |
© 2024 MH Sub I, LLC dba Internet Brands