Description:

- Reduced gaps compared to the OEM parts.

- Uses the original mounting points and clips.

- Made from UV, heat and water resistant material.

- Easy to sand and paint.

Tested on several C36 bumpers to make sure it would fit any C36 AMG.

The hole for your temperature sensor might be bigger than the one on our piece - you'll need to drill it bigger if it's the case.

Please note that they are painted as an example, yours will come unpainted, black. THEY ARE REPRODUCTIONS, NOT OEM PARTS. The retaining clips are also reproductions.

This includes a PAIR of covers (left and right) and the four (4) retaining clips.

//

We started from the original covers and we worked from there to remove uneccessary OEM gaps while keeping enough to fit with some wiggle room. Because all the bumpers weren't made equals, we tested our covers on two C36 to make sure that our OEM covers weren't flawed from the start. We also noticed that the driver side cover doesn't have the temp. sensor bracket on the same side of the cover depending on the model year - while this doesn't cause a problem, the sensor itself isn't the same diameter. Therefore, we made the hole for the smaller sensor but it can be drilled out to fit the other one.

We also went ahead and made sure that the backside is as strong as the front since we need to make sure that the grooves for the clips are plenty strong. We are using the exact same design as the original and we even reproduced the clips, which will be included with the covers.

They are made from UV, heat and water resistant material. They are extremely easy to prepare for paint as barely any sanding is required; you could probably get away with using only high build primer. The contour of the parts are as clean, if not better, than the original parts.

Contact me if you need more informations.