Any help with y66/1-104,08-no start, limp mode
Hello everyone-I'm in need of help with this transmission code listed above. There is no start when I turn the key. Car can be started from fuse box and drive in limp mode. These codes were pulled from iCarsoft MBII. Thanks in advance!!
|
1 Attachment(s)
Originally Posted by dluckie76
(Post 7140089)
Hello everyone-I'm in need of help with this transmission code listed above. There is no start when I turn the key. Car can be started from fuse box and drive in limp mode. These codes were pulled from iCarsoft MBII. Thanks in advance!!
if fluid is found , clean the tcu then replace the conductor plate and electrical connector on the transmission to prevent more fluid from leaking and damaging the tcu again Attachment 360644 |
Thanks bro...did that. No trans residue. Did notice a lil bit of green residue like possible water. Pulled out TCU cleaned with electric cleaner; still a no go.
|
Is y66/1 lock solenoid located on the conductor plate or the actual shifter?
|
Any solutions to y66/1 solenoid trouble code?
|
In need of help
Where is the y66/1 r/p solenoid located? I'm getting DTC 104 and 008. Anything over 96 is a stored code; which leaves me 008 r/p lock solenoid. No start, can jump from relay box, limp mode. I have changed the conductor plate-no change.
|
A 30-second search on Google shows that the Y66/1 solenoid is the one in the shifter that moves the shift lever locking arm.
|
All times are GMT -4. The time now is 11:48 AM. |
© 2024 MH Sub I, LLC dba Internet Brands