WIS Procedure Needed - W221 S63AMG - Rear Camber Strut/Control Arm
#1
Junior Member
Thread Starter
WIS Procedure Needed - W221 S63AMG - Rear Camber Strut/Control Arm
I just posted this request for assistance in the Technical Assistance section and am not sure if it's appropriate to list the same thing twice - forgive me if it isn't.
I am hoping someone would be able to post PDF copies of the WIS procedures for changing out the REAR Upper camber/strut control arms (left and right sides). I do not have access to my laptop at this time to pull my own copies and have a concern that might prevent me from beginning this project today. I'd like to see how it's done by MB before proceeding.
My VIN: WDDNG77X99A273786
Parts I'm looking to remove and replace (there seems to be a number of interchangeable part numbers for the same pieces):
Left (driver) side rear:
A2203521005 (actual part on car)
A2213500406
A2223500132
Right (passenger) side rear:
A2213500606
A2223500232
Thank you in advance to any forum members who can offer assistance. I will post a write-up of the procedure once complete (I'm actually changing out these arms for adjustable units, if that is of any interest to other members),
Thanks,
Simon
I am hoping someone would be able to post PDF copies of the WIS procedures for changing out the REAR Upper camber/strut control arms (left and right sides). I do not have access to my laptop at this time to pull my own copies and have a concern that might prevent me from beginning this project today. I'd like to see how it's done by MB before proceeding.
My VIN: WDDNG77X99A273786
Parts I'm looking to remove and replace (there seems to be a number of interchangeable part numbers for the same pieces):
Left (driver) side rear:
A2203521005 (actual part on car)
A2213500406
A2223500132
Right (passenger) side rear:
A2213500606
A2223500232
Thank you in advance to any forum members who can offer assistance. I will post a write-up of the procedure once complete (I'm actually changing out these arms for adjustable units, if that is of any interest to other members),
Thanks,
Simon