Oil Filter Installation
#1
Member
Thread Starter
Oil Filter Installation
Today I did an oil and filter change on a m176 engine. The oil filter is on the bottom.
It was quit a simple job to do and after completing it I began to question if I installed the filter correctly. I say this because the filter is flat on one side and the other side has a few minor tabs.
which end goes into filter housing?
It was quit a simple job to do and after completing it I began to question if I installed the filter correctly. I say this because the filter is flat on one side and the other side has a few minor tabs.
which end goes into filter housing?
The following users liked this post:
Nice Ride (06-21-2024)
#4
Member
Thread Starter
#5
Senior Member
Today I did an oil and filter change on a m176 engine. The oil filter is on the bottom.
It was quit a simple job to do and after completing it I began to question if I installed the filter correctly. I say this because the filter is flat on one side and the other side has a few minor tabs.
which end goes into filter housing?
It was quit a simple job to do and after completing it I began to question if I installed the filter correctly. I say this because the filter is flat on one side and the other side has a few minor tabs.
which end goes into filter housing?