SL/R129: Door panel not sitting flat
Thread Starter
Member
Joined: Oct 2007
Posts: 109
Likes: 6
From: Seattle
2002 G500, 1961 190b, 2001 SL500 Sport
Door panel not sitting flat
I just got this 2001 SL 500 Sport and noticed that the panel is bowed a little. I tried to push it back on but it pops back out. Any ideas what's causing this?
It's very slight but it's bowed under the mirror in this picture. I can get a better picture tomorrow. It's the plastic moulding, not the sheet metal door. There's a slight gap between the moulding and the door.
Thanks
It's very slight but it's bowed under the mirror in this picture. I can get a better picture tomorrow. It's the plastic moulding, not the sheet metal door. There's a slight gap between the moulding and the door.
Thanks
Last edited by miike; Nov 1, 2016 at 07:37 PM.
MBWorld Fanatic!
Joined: Jan 2009
Posts: 9,225
Likes: 1,798
From: V E G A S
1922 Ford Model T / no OBD
I just installed the panel on car I recently bought.
The way it is fastened is that you have a row of plastic pegs in upper part of panel that go into keyholes cut horizontally. So you insert the panel about 1" to the outer edge, even up top and slide it 1" to the front.
Bottom pegs are just press in and you finish with the screw at door edge.
Looks to me like 1 of the upper pegs is not in the hole, or broken, so you have to reverse above procedure and see what is happening.
The way it is fastened is that you have a row of plastic pegs in upper part of panel that go into keyholes cut horizontally. So you insert the panel about 1" to the outer edge, even up top and slide it 1" to the front.
Bottom pegs are just press in and you finish with the screw at door edge.
Looks to me like 1 of the upper pegs is not in the hole, or broken, so you have to reverse above procedure and see what is happening.
MBWorld Fanatic!
Joined: Jan 2009
Posts: 9,225
Likes: 1,798
From: V E G A S
1922 Ford Model T / no OBD
Everything is easy when you know how to do it.
Ask me how many pegs I broke in my life because I was pulling them in wrong direction.
X-ray vision is still in development stage.
Ask me how many pegs I broke in my life because I was pulling them in wrong direction.
X-ray vision is still in development stage.
