Longtube Headers and X pipe $900 shipped in the USA
The following users liked this post:
builtbyfood (12-12-2016)
#61
So far only one or two people have installed these exhaust components, as far as I know from the facebook group message. Myself being one of them, I will say that you get what you pay for.
The following users liked this post:
builtbyfood (12-15-2016)
#69
Former Vendor of MBWorld
Thread Starter
iTrader: (1)
Join Date: May 2008
Location: Houston
Posts: 12,139
Received 292 Likes
on
241 Posts
2003 W211 E55, 2003 W220 S600
To be honest there is no market for even 30 sets for each platform. It would be very hard to bring the cost down.
You are better of contacting MBH and asking them for killer pricing on 1 set.
You are better of contacting MBH and asking them for killer pricing on 1 set.
#73
Former Vendor of MBWorld
Thread Starter
iTrader: (1)
Join Date: May 2008
Location: Houston
Posts: 12,139
Received 292 Likes
on
241 Posts
2003 W211 E55, 2003 W220 S600
As per the manufacture / projectb5 you may need 2 additional clamps that can be purchased from less than $5 you can match them up to existing ones in the box.
#74
Member
Passenger side
Inside the driver side.
Passenger side again. I did not get a shot of the driver side, was distracted during the install.
X pipe
Installed
hangs slightly lower.
Passenger side from engine bay
Driver side from engine bay, there is no rubbing, but it is very tight. The steering shaft should be disconnected. It is a ton easier,
The following users liked this post:
shardul (01-03-2017)
The following 2 users liked this post by Papieye:
Nor Cal SL55 (02-21-2017),
shardul (01-03-2017)