Car Pulling When Braking?!!?
#1
MBWorld Fanatic!
Thread Starter
Car Pulling When Braking?!!?
So I noticed after I got an alignment, when I press the brakes, it pulls to the left....I googled it and many people say it could be tons of things, so just wondering if anyone else had this problem?
#3
Senior Member
Join Date: Mar 2009
Location: USA, EU
Posts: 430
Likes: 0
Received 5 Likes
on
5 Posts
06 E320 CDI (GONE), 14 Jeep GC EcoDiesel, 01 Disco II (GONE), 09 BMW X3 3.0 Si Xdrive
Alignment issues.
According to MB, if car pulls to the left or right when breaking at low speed you have worn lower ball joint on that side. Maybe there is been some tolerance keeping the car straight, which is gone after the alignment.
#4
MBWorld Fanatic!
Thread Starter
Well car still pulls but found out on the left side i need a new ball joint....the mechanic at shell was like i need to get the whole control arm......is this true?
#5
MBWorld Fanatic!
Join Date: Mar 2006
Location: Louisiana
Posts: 3,254
Likes: 0
Received 12 Likes
on
12 Posts
03 E500 and Corvette
On some the ball joint is part of the control arm. Newer models the ball joint can be replaced vs the entire arm. Depending on your model there may be a new arm for yours with the replacable joint, so check when buying part.s
#7
Senior Member
Join Date: Mar 2009
Location: USA, EU
Posts: 430
Likes: 0
Received 5 Likes
on
5 Posts
06 E320 CDI (GONE), 14 Jeep GC EcoDiesel, 01 Disco II (GONE), 09 BMW X3 3.0 Si Xdrive
if is the control arm ball joint you can replace only the joint, if is the torsion arm ball joint you will have to replace the arm because the ball joint is part of the cast.