Driver's Door Lock Stopped Working
#1
Member
Thread Starter
Join Date: May 2003
Location: Washington DC / No. Virginia; and Cape Cod, MA
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
'71 280SE
Driver's Door Lock Stopped Working
The central locking system on my daughter's '93 190E was working perfectly until recently.
Now, when she tries to lock it from the driver door nothing happens at all. Yet, the passenger door and trunk both still work to lock the entire car.
Any thoughts?
Thanks,
Ed
Now, when she tries to lock it from the driver door nothing happens at all. Yet, the passenger door and trunk both still work to lock the entire car.
Any thoughts?
Thanks,
Ed
#2
MBWorld Fanatic!
probably the lock actuator. both of mine are dead. id check the vacuum hoses first though. pump some air into the line that goes into the pump under the rear passenger sides side and see if it hold the psi, if it doesnt just find the leak
#3
Junior Member
Join Date: Nov 2007
Location: Dana Pt, CA
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
'95 c280 '93 190E '07 C230
190 drivers door lock
I had the same problem with my '93 and I replaced the door lock which solved the problem. By now though you probably have already solved it too!
#4
Member
Join Date: Nov 2008
Location: San Francisco, California
Posts: 76
Likes: 0
Received 1 Like
on
1 Post
1993 190E 2.6
I have the same problem as well on my '93. My dad fixed it cause the wires broke that connected to the lock. It broke again after 3 years. Not bad for a jury rig job. So just gotta find time to open the door panel and do it again.
#5
Member
Thread Starter
Join Date: May 2003
Location: Washington DC / No. Virginia; and Cape Cod, MA
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
'71 280SE
My daughter has had the car away at college. She'll be back this week, and I'll try to take a look at it if it's not too cold.
I may be back in touch with you gents when I tackle this project. Are there any diagrams of the door's insides on the net?
Cheers,
Ed
I may be back in touch with you gents when I tackle this project. Are there any diagrams of the door's insides on the net?
Cheers,
Ed
#6
Junior Member
Join Date: Nov 2007
Location: Dana Pt, CA
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
'95 c280 '93 190E '07 C230
190E door lock problems
Once you remove the panel replacing the door lock mechanism is pretty straight forward.