C230 Kompressor Engine problem???
#1
Senior Member
Thread Starter
C230 Kompressor Engine problem???
http://www.youtube.com/embed/1DnQQPyoSqs
So yeah if this has happened, any help would be appreciated before the new year. Sucks
So yeah if this has happened, any help would be appreciated before the new year. Sucks
#4
Senior Member
Thread Starter
Okay I'm gonna do the cps tommorow so well see if that fixes that. The thing is my car starts, has asr/bas light on. When I step on the gas is does not floor it, like run the engine, all I hear is me stepping the pedal and hearing a low rev, and I mean low. I don't know if the coils might be the problem, so well see if it comes to that, it has oil in the air intake box, and its drivable, like its a struggling badly. I was hoping me posting a video refresh some peoples mind about the sound of the engine and it shakes a lot.
#5
MBWorld Fanatic!
Lets see 120k and 200 miles past the latest scheduled maintenance.I would start fresh with - new plugs, fuel filter,air filter.The way the motor is shaking you probably need engine mounts.At 120k its probably a safe bet the O2 sensors are going so you might want to look at those too.The car sounds like its gasping for air so I would look around for a vacuum leak AFTER I addressed the above mentioned items.Can you give us a little history on the maintenance ( or lack there of ) ?
#6
Senior Member
Thread Starter
I did oil change in August, did trans service in March plus oil change, replaced water pump, replaced maf, replaced drag link, ball joints, arm bushings, charcoal filter, air filter, fuel filter, oil filter. All new within the year of 2011. Where are the 02 sensors at?
#7
MBWorld Fanatic!
You should have 2 o2 sensors - 1 pre-cat & 1 post cat.Look underneath the car along the exhaust system.
Trending Topics
#8
Senior Member
Thread Starter
So I bought the cps sensor, two coils, 4 spark plugs, trans mount, engine mounts, brake pads, brake rotors, oil filter, Mobil1. So i hope after all this the car runs good again.
#9
Senior Member
Thread Starter
Hey it fixed the problem, the new coils and spark plugs and the cps sensor. Pronlem is that on the SDS i kinda made my engine control unit says no codes, it other works i thinkk its uncoded, how the hell do i fix that and 2nd, the Emergency brake came loose, anyone ran into this sort of problem before?