Dumb question about CD changer install
Thread Starter
Banned
Joined: Jul 2002
Posts: 265
Likes: 0
Dumb question about CD changer install
OK. I installed the correct (used) CD changer in my C320 without incident. However, the display still says "NO CHANGER" and the CD cassette will not eject when I push the (only) button. (BTW, there is power and the light in the button flashes.)
The first was not a BIG surprise as I had been warned that this sometimes happens and requires MB reprogramming.
The second suggests that this is a defective changer unless I am missing something very obvious. Just push button to eject, no?
The first was not a BIG surprise as I had been warned that this sometimes happens and requires MB reprogramming.
The second suggests that this is a defective changer unless I am missing something very obvious. Just push button to eject, no?
Thread Starter
Banned
Joined: Jul 2002
Posts: 265
Likes: 0
Yes, it was the Bose-compatible cable according to the package it came in. Besides, the rest of the audio system still works as it did before which suggests to me that the hook-up is correct.
OTOH, that should not affect the eject button, should it?
OTOH, that should not affect the eject button, should it?
Member
Joined: Apr 2002
Posts: 187
Likes: 0
From: new jersey
C230 K
When I installed a used CD changer initially I used a “bad” cable (for Bose units) and I got the same message “NO CHANGER" but I was able to eject/insert the Cd cartridge. After getting the Non Bode cable everything was fine, did not have reprogram anything. Hope it helps.
