Pulley install on Automatic Trans car
#1
MBWorld Fanatic!
Thread Starter
Pulley install on Automatic Trans car
Linh and I did a pulley install on an automatic car and it wasn't too much harder. To keep the motor from spinning there's a rubber plug under bell housing that you pull off, slip something thick in there to keep it from rotating and we were able to torque the pulley to 200 ft-lbs torque. If anyone needs a pulley install done in So Cal, he'll do it for $50.
Here's a pic of the hole. This is between the engine and tranmission so you'll have to remove the plastic belly pan behind the one for the engine to expose this.
Here's a pic of the hole. This is between the engine and tranmission so you'll have to remove the plastic belly pan behind the one for the engine to expose this.
Last edited by Buellwinkle; 02-16-2003 at 08:25 PM.
#4
MBWorld Fanatic!
Thread Starter
Linh will do it, call him now, operators are standing by.
(619) 972-4114
or e-mail him at
ldnguyen1970@hotmail.com
(619) 972-4114
or e-mail him at
ldnguyen1970@hotmail.com
#6
MBWorld Fanatic!
Thread Starter
If you don't like that design then ask Lee about sending in your factory pulley and he'll add a ring for you like Renntech. For the steel hub transplant he removes the alluminum hub, presses in a steel hub in it's place and then screws a half dozen flush mount screws to further secure it, looked solid to me or I woudn't have put it on. Screws can't back out because the washers are in the way.
Trending Topics
#8
Thanks
linh just told you about it:-) I emailed him asking the pictures because I'm installing my pully probablyt omorrow (first W202 with ASP)
Check out my thread about dyno, I need you input because I had BAD numbers.
Etienne
linh just told you about it:-) I emailed him asking the pictures because I'm installing my pully probablyt omorrow (first W202 with ASP)
Check out my thread about dyno, I need you input because I had BAD numbers.
Etienne
#11
#12
MBWorld Fanatic!
Thread Starter
Originally Posted by silverLorinserC
where can i get a pully for 02 c240 sedan? oh and how much?