Low Oil Level?? After oil change
1. No key in ignition
2. Insert key, turn to position 1
3. Press "Page Down" steering wheel button (lower right button on the left side) to select any MFD display other than the trip odometer or you will reset your trip odo)
4. Press and hold the reset button (left edge of instrument cluster) until you hear a beep...takes a while, about a minute
5. Press "Page Down" button again once
6. You will see the dyno mode display with oil level values in 'dashes'
7. Turn key to position 2 and wait until system measures oil (several seconds)
because i remember the mechanic telling me the car takes 7.5 quarts or liters and i read online that this car takes 8.5. So after i followed these steps it says that my engine oil level is 6.1 (when cold) and when i start my car it drops down to 5.5 after 30 seconds, on the instrument cluster.
I was just wondering, if the computer is measuring the oil level correctly? Do you guys think the car was acting weird because the mechanics didn't add enough engine oil?
Please help.
Sorry, i didn't get your first question. Do i find the value from the same spot where it tells you what your engine oil level is?
In the pictures, you will notice that at 12:20 pm(car was cold) the reading says my engine oil level is 6.5 1. And then at 12:46 pm- the oil level says 5.9 1( this was after i started my car a couple times, but didn't drive it)
Thanks for helping me out, i appreciate it.


