m271 rubber seal found in valve train
#1
Newbie
Thread Starter
m271 rubber seal found in valve train
hi
my m271 slipped timing chain, open up valve cover found 5 x broken rockers and this red square rubber seal. No compression on all intake cylinders, presume all or most valves bent
Any one know where red seal could have come from?????
Pic attached
my m271 slipped timing chain, open up valve cover found 5 x broken rockers and this red square rubber seal. No compression on all intake cylinders, presume all or most valves bent
Any one know where red seal could have come from?????
Pic attached
#3
MBWorld Fanatic!
It's quite small though, compared to a lighter in the background... Maybe a dust/water gasket from some connector?
See yellow thing in the pic:
See yellow thing in the pic:
The following users liked this post:
sjpenny (04-15-2017)
#4
Newbie
Thread Starter
thanks vvf you put me on right track, seems to fit intake crank shaft position sensor, must fallen in removing manifold
Last edited by sjpenny; 04-15-2017 at 12:54 PM.
#5
Member