Install LED taillamps in a 2013 G63 AMG
#1
Newbie
Thread Starter
Install LED taillamps in a 2013 G63 AMG
I have been battling installing a new set of LED taillamps on my G63 Wagon.
OEM wires out of the vehicle are as follows;
Brown ~ Negative ground
Black ~ Brake light
Red/Gray ~ Driving light
Green/Black ~ Turning light
The Brake light works, The Turning signal works, but when I turn on the Driving/Parking lights the light will turn on the go off .. a few seconds later I get a Error Code on dash.
SO... I installed the 25am resistor, on the Red/Gray wire.. with one end connected to the Brown negative ground... and again, Error Codes.. I have tried as many combinations as I could think of...
Has Anybody had these issues ??
OEM wires out of the vehicle are as follows;
Brown ~ Negative ground
Black ~ Brake light
Red/Gray ~ Driving light
Green/Black ~ Turning light
The Brake light works, The Turning signal works, but when I turn on the Driving/Parking lights the light will turn on the go off .. a few seconds later I get a Error Code on dash.
SO... I installed the 25am resistor, on the Red/Gray wire.. with one end connected to the Brown negative ground... and again, Error Codes.. I have tried as many combinations as I could think of...
Has Anybody had these issues ??