Sunroof seal instalation
03-01-2022, 06:17 PM
#1
Junior Member
Thread Starter
Sunroof seal instalation
Hi everyone.
So, in the last few days I installed a new sunroof rubber seal on my car (much due to poor weather, some leakage inside because of clogged drains, etc.).
For that, I used a mixed usage of the factory instructions, and removing the glass. However, when installing the glass, I noticed that it was very snug, and it needed a little persuasion to get the glass on to the rails.
I opened the sunroof, and it worked fine, but when I tried to tilt it, it simply blocks up. (the sunroof seals great, and it is all the way pushed inside the rails, or so it seems)
With this, does anyone have any tips for getting the sunroof to tilt?
Thanks in advance!
So, in the last few days I installed a new sunroof rubber seal on my car (much due to poor weather, some leakage inside because of clogged drains, etc.).
For that, I used a mixed usage of the factory instructions, and removing the glass. However, when installing the glass, I noticed that it was very snug, and it needed a little persuasion to get the glass on to the rails.
I opened the sunroof, and it worked fine, but when I tried to tilt it, it simply blocks up. (the sunroof seals great, and it is all the way pushed inside the rails, or so it seems)
With this, does anyone have any tips for getting the sunroof to tilt?
Thanks in advance!
