AZN'S NEW LED REVIEW THREAD
My initial thoughts:
The light source is definitely more noticeable than the polarg I've been using or the iJDMtoy set I have. Especially from close-up (up to 10-20ft). If you look for it really close-up you can almost see the four forward facing led bulbs on each of them.
The color pattern seems pretty good even on the edges of the eyelid. One set I had tested previously looked fairly white from the front but from the side of the eyelid it looked purple. Not having that problem with these.
They are whiter & brighter than the polarg without being blue. Maybe a very discerning eye will see a blue tint but WAY better than any other LED I've tested or seen.
They are more visible during the day than either the stock bulbs or the polarg bulbs. They don't have that 'Audi brightness' I think some of us would like but they are brighter. This morning it was a little overcast outside and they were noticeably brighter than the polarg I had in the other eyelid, but when I compared them again this afternoon in the direct sunlight, they were washed out and couldn't really tell they were on.
They wouldn't work when I seated them the whole way into the socket. I had to pull them out 1/8" which leaves them room to vibrate and move side-to-side a bit, but at least they light up.
Anyone else notice this??Oh and they get holy frickin hot, burnt my finger last night adjusting one of them.
im in love with them though, their a LITTLE bit brighter than my 5000k but im fine with it. everything matches up well imo.
i went to the gym last night, drove through the parking lot with just the eyelids and fogs. had peoplee staring. good stuff good stuff. haha
The Best of Mercedes & AMG
i have 5000k HIDs
Being as they are LED's they are longer than the halogen counterparts and in my experience, harder to maneuver into the sockets when replacing them. Also, after I had installed them all one of my blue 8000k bulbs weren't working. So I pulled it out and flipped it around, and then it started to work fine.
So I am wondering, does it matter which sides touch the sockets, or was it just a fluke?
Even with my Tint Lamin-X on my headlights, I still see my LED's fine. But the tint has made my blue look a bit purplish. Might have to paint my headlight now instead.
I have the Polargs and the color is GREAT and matches everything perfectly but yes, they are not that bright...
Also, are you also running these new LED's in your sidemarker lights too AZN??? Whatever is in there looks great, and I am thinking I am going to replace my Polargs with whatever you have

Thanks in advance
RB
















