pics of drilled dust caps?
#1
Member
Thread Starter
Join Date: Mar 2011
Posts: 169
Likes: 0
Received 0 Likes
on
0 Posts
99' Toyota Corolla
pics of drilled dust caps?
Just curious where you guys are pullin these wires through. Thanks!
did a little search but couldnt find any real good shot of it
did a little search but couldnt find any real good shot of it
#4
MBWorld Fanatic!
Join Date: Nov 2007
Location: SFV CA
Posts: 4,433
Likes: 0
Received 5 Likes
on
5 Posts
2008 Black Out C350 Saks Edition / 87 VW GTI
Did you have two rubber dust caps included in the kit? If so, drill a hole big enough to installed the cap and pass the wires though the cap, check the sticky DIY thread for HID lights.
#6
Junior Member
Join Date: Aug 2010
Location: Ohio
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
C300
Trending Topics
#8
Member
Thread Starter
Join Date: Mar 2011
Posts: 169
Likes: 0
Received 0 Likes
on
0 Posts
99' Toyota Corolla
i had seen a really small pic of people drilling on the edge of the cap and just passing the wiring through, but i really couldnt see it very well so i was hoping someone had a good pic of it, or if the center drill method
thanks for your help everybody
thanks for your help everybody
#9
Junior Member
Join Date: Aug 2010
Location: Ohio
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
C300
One thing I forgot to mention about the pic is that the hole (7/8" as directed by DDM's instructions, but was on a rubber/flimsy cap not a hard cap like ours) was slightly too small. I had to cut a small notch in it to fit one of the connectors through. I work at a manufacturing firm, so I had one of our machinists help me out during lunch break. Otherwise, I probably would have tried the notch in the side method as well. As you can tell, there aren't that many wires to fit through.