2008 C300 Starting Issues
#1
Newbie
Thread Starter
2008 C300 Starting Issues
Today when I went to start my C300 I turned the key, the engine cranked for a bit but did not start. I tried about 6 more times before it started. The car had been sitting for a couple of months without being started.
I drove to my first appointment….. about 15 minute drive. I came out after about an hour and the car started right up. Drove another 15 minutes to my next appointment ….. came out about an hour later, and I had to try about 6 times before the car started. There were no check engine lights and the car performed fine, once it started.
The battery is 7 years old and the vehicle is driven very infrequently. Could the battery be the issue??
I drove to my first appointment….. about 15 minute drive. I came out after about an hour and the car started right up. Drove another 15 minutes to my next appointment ….. came out about an hour later, and I had to try about 6 times before the car started. There were no check engine lights and the car performed fine, once it started.
The battery is 7 years old and the vehicle is driven very infrequently. Could the battery be the issue??
#2
MBWorld Fanatic!
Join Date: Sep 2013
Location: Houston, Texas (area)
Posts: 1,479
Received 398 Likes
on
328 Posts
2021 GLB250 FWD, 2023 GLA250 FWD, 2013 C250, 2015 GLK350, 2005 ML350, 2003 E320
That’s a common symptom of the crankshaft position sensor beginning to fail. A 7 year old battery can be tested and may need replacement but is unlikely to cause this.
#3
Newbie
Thread Starter
Problem Solved - Easily
The problem was a simple one to fix ……. Replaced the battery and all is well!
When the battery has low amperage it basically triggers a sensor to not start.
When the battery has low amperage it basically triggers a sensor to not start.
The following users liked this post:
Odd Piggy (12-29-2022)
#4
Newbie
Thread Starter
The problem was a simple one to fix ……. Replaced the battery and all is well!
When the battery has low amperage it basically triggers a sensor to not start.
When the battery has low amperage it basically triggers a sensor to not start.