Automatic bumps in D and sudden powerloss.
#1
Junior Member
Thread Starter
Join Date: Mar 2014
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
C350
Automatic bumps in D and sudden powerloss.
Hello,
I have a 2007 W204 RWD C350.
So yesterday I was in my car driving on a 60 km's road and it was quiet.
I decided to drive a little faster, tried to give more gas, I noticed that I had power loss.
At the traffic light few times gas given and some kick downs and it went very slowly and the RPM went up.
Once stopped at a gas station i tried several times switching to P R N D, and it came out that the automatic transmission bumped in D.
So I decided to turn off the car and wait a little bit.
A few minutes later i started the car, no problems with the bump in D or power loss. (i think the ECU has resetted itself?)
So i quickly drove back home without any problems.
And today i started the car and was trying out the P R N D without any problems.
So I was wondering what could be the cause of the sudden bump in D and the power loss?
Sincerely,
Aegyo
I have a 2007 W204 RWD C350.
So yesterday I was in my car driving on a 60 km's road and it was quiet.
I decided to drive a little faster, tried to give more gas, I noticed that I had power loss.
At the traffic light few times gas given and some kick downs and it went very slowly and the RPM went up.
Once stopped at a gas station i tried several times switching to P R N D, and it came out that the automatic transmission bumped in D.
So I decided to turn off the car and wait a little bit.
A few minutes later i started the car, no problems with the bump in D or power loss. (i think the ECU has resetted itself?)
So i quickly drove back home without any problems.
And today i started the car and was trying out the P R N D without any problems.
So I was wondering what could be the cause of the sudden bump in D and the power loss?
Sincerely,
Aegyo
#4
Junior Member
Thread Starter
Join Date: Mar 2014
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
C350
These are the diagnose codes i got.
PC121 CAN communication with traction control disturbed. No communication.
PC164 CAN Signal conditioning system. Not present.
P0717 turbine speed sensor. signal missing
I think it's the P0717 code that causes the limp mode?
What should i do now?
PC121 CAN communication with traction control disturbed. No communication.
PC164 CAN Signal conditioning system. Not present.
P0717 turbine speed sensor. signal missing
I think it's the P0717 code that causes the limp mode?
What should i do now?