Halter Bracket Installation Help?
#1
Newbie
Thread Starter
Halter Bracket Installation Help?
I need help with installing the handle/halter/bracket of the trunk flooring. Any Ideas from someone who came across the same issue? It looks straight forward but I think it needs a little bending and I am not sure if this would break it again. If you have it already installed, a clear pic to illustrate how it is mounted from the back would really help. Thanks a lot.
#2
Super Member
I'll get a picture later today, but the long top piece circled does bend down and clips onto the smaller piece after inserting it in the trunk flooring to secure it. Bending it should not cause it to break. If you're super concerned about it breaking while you bend it, make sure the piece isn't cold when you bend it. Very used to snapping pieces of plastic on cars here in Canada when it gets cold.. but most of the stuff on these cars seems to be fine in any temperature. (I'm looking at you, BMW)
The following users liked this post:
Mando (01-24-2017)