C250 High beam issue - MBWorld.org Forums

Oct 12, 2020 | 05:26 AM

sheba

Thread Starter

Newbie

Joined: Oct 2020

Posts: 2

Likes: 0

C250 4M

C250 High beam issue

Hello,

Long short story, car was hit by animal and broke headlight and bumper, but in my C250 2013 there was ILS Headlight witch was replaced by non-OEM Headlight who doesnt have that function. Without my knowing anything about that headlights,because i was away due to work

.

Im struggling to get my High Beams working and proper turn signal lights(getting error message but i assume i need to put load resistor ), i was looking in drawing but cant find what wire is high beam signal?
What i found so far there is difference in harness, i mean on my car there is no wire that should be for high beam shutter, i hope i can rewire harness.
After searching and measuring there is layout
Harness on my car side and headlamp :

Car Side
1. Black-Green BKGN / Turn Signal
2. Blue-White BUWH / I think this is for range and other adjustments
3. Grey-White GYWH / Standing Light / C Light
4.
5. Brown BN / Negative
6. Yellow YE / Low Beam
7.
8. Green-Blue GNBU / I think this is for range and other adjustments
9. Black-Blue BKBU / I think this is for range and other adjustments
10. Brown BN / Negative
11. Red-White RDWH /
12.
13.
14.

Headlamp Side Pins

1. Turn Signal.
2. Goes to Motor for Leveling
3. C Light
4.
5. Negative
6. Power supply to ballast
7. Shutter for high beam.
8.
9. Goes to Motor for Leveling
10. Negative /Goes to Motor for Leveling
11.
12.
13.
14.

Im ok without ILS, but i really hope there is any possibility to get high beam working.
I hope there is any suggestion that would help me