Subframe bushes front carrier bent?
#1
Senior Member
Thread Starter
Subframe bushes front carrier bent?
I'm doing a rear subframe restoration on a c180.
while pressing out the subframe bushes I noticed one side of the bushes carrier looks bent.
Picture is of the suspected side, looks like I might draged on the side increasing the gap between the two halfs compared to the other side.
Can anyone confirm if this is bent or snap a picture of their bush, this would be front right of the rear subframe?
Looking from above it looks like the bush will still go in straight. No clue how I bent it since I'd press with a small socket in the middle due to the bush being bad anyhow.
while pressing out the subframe bushes I noticed one side of the bushes carrier looks bent.
Picture is of the suspected side, looks like I might draged on the side increasing the gap between the two halfs compared to the other side.
Can anyone confirm if this is bent or snap a picture of their bush, this would be front right of the rear subframe?
Looking from above it looks like the bush will still go in straight. No clue how I bent it since I'd press with a small socket in the middle due to the bush being bad anyhow.
Last edited by Dokus; 12-17-2020 at 06:28 PM.