When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
so I picked up a set of silvers coilers a couple of weeks back, the plan was to have them installed but decided to do it myself as I have some time off and I wasn't looking forward to paying some one close to $2000 (CAN$) for install
I got the drivers side rear done no issues but the passenger side ran into a issue.. all the how too's I've seen/read no one seems to have had this issue or they don't mention it.. Any tips or solutions ?
here's a sneak peek for the rears. took me while to set height/preload first time dealing with a divorced set up. fronts gonna have to wait until tomorrow.
oh and ended up just jacking the exhaust up out of the way. before
had some time to finish off the install today. went pretty smooth no issues, drivers side end link was bit loose but seemed to have tightened up just fine. Mt have to replace but will take another look at it when car goes for aliment. next week.
think the rear needs to come up a bit, its 1/2" higher than the front.
02-03-2024, 04:52 PM
