Kleemann - Rebuilt v2.0
Super Member
Joined: Jan 2007
Posts: 617
Likes: 1
From: San Diego
MB
MBWorld Fanatic!
Joined: Dec 2005
Posts: 2,347
Likes: 1
From: So Cal
2006 Weistec 3.0L SC'd C55, 2006 MaxPsi PT6466 Turbo'd M3, 2019 Maserati GTS , 2020Alfa Quadrifoglio
The question is...Will those wheels clear his Brembo Monoblock GTs? I don't think you have the big brakes in the rear like he does. If you can guarantee they will clear, I'll paypal you the money tonight.
Junior Member
Joined: Jan 2010
Posts: 44
Likes: 0
From: Jakarta, Indonesia
CLK 320 1998, Honda Odyssey 2008, Honda CR-V 2007 (sold), Civic (sold), 1992 Accord (sold)
Hi Alumar,
Just curious, how long have you had this kleemann supercharger before having it rebuilt? How much was the cost (you could send me pm if you dont mind)? I am looking to install one and looking for as much info as possible. Thanks mate.
Cheers,
Olie
Just curious, how long have you had this kleemann supercharger before having it rebuilt? How much was the cost (you could send me pm if you dont mind)? I am looking to install one and looking for as much info as possible. Thanks mate.
Cheers,
Olie
Guys as I mentioned before, the Kleemann was pulled apart, engine cleaned/polished which included complete breakdown to head, new gaskets etc; supercharger rebuilt/port & polished; new plugs, coil packs, wires, MAF Sensor, ERG Valve, 40+ Dyno Tuned @ Kleemann in Colorado
Cory's results in Colorado /w 2lb loss @ 6700ft sl
467RHWP
470RWHP
I got it back last friday and took it over to a local Mustang Dyno (300ft sl)
Final STD results
487RWHP
479RWTQ
Final SAE results
479RWHP
470RWTQ
AF was 12.6->11.9 through the range until 6400rpm it went to 11.5
Virtual 1/4 results - (1/4 run on the dyno, load enabled)
11.66 ET @ 124.76MPH
Midnight madness next weekend at Gateway International should be quite interesting
Plots and graphs posted the momment I get them sent over digitally
Cory's results in Colorado /w 2lb loss @ 6700ft sl
467RHWP
470RWHP
I got it back last friday and took it over to a local Mustang Dyno (300ft sl)
Final STD results
487RWHP
479RWTQ
Final SAE results
479RWHP
470RWTQ
AF was 12.6->11.9 through the range until 6400rpm it went to 11.5
Virtual 1/4 results - (1/4 run on the dyno, load enabled)
11.66 ET @ 124.76MPH
Midnight madness next weekend at Gateway International should be quite interesting
Plots and graphs posted the momment I get them sent over digitally
Former Vendor of MBWorld
Joined: May 2009
Posts: 2,305
Likes: 93
From: Valley of the Sun, Arizona
C63, SL55, E55, CLS55, ML63, C55
Alumar's case is a bit different. He didnt have it rebuilt because of a failure. Some one tried to steel it from his garage and messed his car all up. It was a total mess. If someone didnt ravage his car he would have had no issues.
Even though this didnt happen to me I'm still bitter about what happened to him.
Even though this didnt happen to me I'm still bitter about what happened to him.
