MY first baseline dyno!
 

they had never dyno'ed a benz before so had a little trouble getting the tach to work...the shop was about 100degrees! and im running a little rich (no fans blasting in front of the car) hopefully ysplitter will help with that a bit) that 241 was him doing it then i said do a 3rd gear pull and all the warnings BAS etc were going off but we didn't need to go into dynomode. only thing the car has is bmc filters and only had time to get in one run! next time a couple runs to get an avg with no cats resonator and ysplitter then comes the pulley/chip =P

i'll have vids/pics of my dyno soon! btw my buddy came with a 03 harley truck SC'ed $400 = pulley/chip 80hp gain!!! and the shop has the worlds fastest 03 cobra (9sec) another guy with a 03 cobra wanted to trade me cars;)


-can anyone host a 1mb vid for me?

roozy, you should dpwnload dynojet's software where you can change settings. It would be neat to compare with a few other C32s.

I'll have mine dynoed in a few months. :P

Norm

what do you mean change settings??

hey roozy, 3rd gear pull hurts HP numbers, you get maximum HP in 4th (i believe 4th is 1:1). you should get better results in 4ths. also the heat can't be good for HP numbers. try and get another baseline dyno, most places will to 3 runs for $75, but i usually get 3 runs for only $35. anyways congrats on the dyno :)


BTW i can host the video for you if you want.

You'll be able to change X and Y settings and MPH/RPMs on the bottom. Time vs. HP can also be compared on the graph. Which might not be an accurate indicator of the rate of accleration but if you had two cars in the same gear making noticeably different power curves the difference would be present. A/F sniffer could be used too. But it is tested after the catylitic converter which might not be that accurate.

http://www.dynojet.com/downloads.shtml

jcanabal and I are going to dyno in the fall and we'll post and compare.

Norm

i dunno
 

but everybody and their son is doing 3rd gear pulls here.


norm - guess i need the shop that did my dyno to save it on disk or email it in that dynojet extension file

I guess that I will do the same also, when I finally get settled in "Texas" Hope to eventually meet members from Texas.

I guess that I will do the same also, when I finally get settled in "Texas" Hope to eventually meet members from Texas.