DIY Black Emblems
I'm thinking an extensive painters tape job should keep my windows clean...I'm going to try it this weekend and will report back on how it all works out.
Last edited by BK63amg; Mar 17, 2011 at 11:24 AM.
I removed all my window trim and had it painted gloss black. the upper trim is one huge piece I could see plasti-dipping being a challenge.
Also the side emblems don't look right all black they turn pretty much unreadable from more than 3 feet away and just look like a black blob. I went back to stock ones after painting them black.
Last edited by JeffDL; Mar 17, 2011 at 10:06 AM.
I'm going crazy because neither Plasti Dip nor Rusto-leum engine enamel (for painting the engine air box) are available in Dubai...
and i can't ship any of those by air!
Too bad hearing about the Plasti dip peeling off under moderate water pressure. That's what I was afraid of.
Last edited by VCA_AMG; Mar 18, 2011 at 06:36 AM.
The Best of Mercedes & AMG

Be sure to do light even coats, and allow it time to properly dry.

Be sure to do light even coats, and allow it time to properly dry.
Last edited by BK63amg; Mar 22, 2011 at 01:52 PM.
I used Mother's Quick Detailing spray and Clay Bar.

Heres the removal..
Remove the two plastic push fasteners on the top of the grille, than push the grille at the bottom where it meets the bumper. This will unclip it from the bumper. Now lift the grille straight up..
__________________
Hey Obsidian, did you have to mask off the gloss plastic parts? I'm not sure what type of surface that plastidip will stay on and what type of surface it will just come off.



