kevy3

Just purchased a set of MBH headers with x pipe and finally got them in hand. Was wondering if there was any cutting or welding needed when removing the stock headers. I was hoping for a direct bolt on with clamps. I just don't want to have to cut out any of the factory exhaust if I don't have too. Any help is much appreciated Thank You

INS1GNIA

You will have to cut.

AMGonFire

if you have the headers mid pipe and the x pipe. You cut absolutely nothing. I know cause I have this set up. It's direct bolt off stock bolt on new no cuts

bluejae

no xpipe for me but there was no cutting. direct bolt on.

SuckaGDog

I'm in DFW as well. I'd like to meet up sometime and hear the headers in person!

That FI group buy has me thinking..

And to OP, no cutting will be required.

layzie12g

Take my advice and install a v band set up. Slip fit on stainless leaks. Mine did and so has every other one I have seen.

kjkidd21

Just add the mid-pipe to your setup and then it will be a bolt-on setup - no cutting or welding. It is WELL worth it - trust me.

kevy3

I have the headers, mid pipe and xpipe I was told there would be no cutting so I'm glad to hear it from people who have it in there vehicle. What is a respectable quote as far as installation now a days?

AMGonFire

550 was what I paid.

kevy3

that's really cheap lol, ive had quotes as far as 1550-1250 usd. its a big job

AMGonFire

if they know what they are doing its a 4 to 5 hour job