Tail Light bulb not working
02-05-2020, 06:30 PM
#1
Super Member
Thread Starter
Tail Light bulb not working
Hello everyone I have a 2002 CL500 and the rear tail lights both have two bulbs on one side the left side both bulbs work but on the other side only the inner bulb works I moved the bulb from the working side to the other and still does not work.. these is quite a bit of rust there, and I was told to fix it I would need to replace the entire tail light what do you guys think?
02-05-2020, 07:30 PM
#2
Hello everyone I have a 2002 CL500 and the rear tail lights both have two bulbs on one side the left side both bulbs work but on the other side only the inner bulb works I moved the bulb from the working side to the other and still does not work.. these is quite a bit of rust there, and I was told to fix it I would need to replace the entire tail light what do you guys think?
put good bulbs in there
when a bulb is blown and in your coding you have "replacement light" or whatever that was called activated the socket with the blown bulb deactivates and is rooted to a working replacement light
If I remember well you just close the car then wait a few minutes then the replaced light should be reactivated
The following users liked this post:
biker349 (02-06-2020)
02-06-2020, 12:37 AM
#3
Super Member
Thread Starter
clean up everything
put good bulbs in there
when a bulb is blown and in your coding you have "replacement light" or whatever that was called activated the socket with the blown bulb deactivates and is rooted to a working replacement light
If I remember well you just close the car then wait a few minutes then the replaced light should be reactivated
put good bulbs in there
when a bulb is blown and in your coding you have "replacement light" or whatever that was called activated the socket with the blown bulb deactivates and is rooted to a working replacement light
If I remember well you just close the car then wait a few minutes then the replaced light should be reactivated
