ABC calibration - MBWorld.org Forums

Oct 3, 2024 | 03:08 PM

dannyfiveforty

Thread Starter

Junior Member

Joined: Aug 2015

Posts: 57

Likes: 2

2008 CL63 AMG

ABC calibration

Hi,
I replaced the level sensor on the front of my car (2008 cl63) and now I can’t get it to calibrate.
I assume I have to do plunger, then level, then load adjustment.

the car starts to do a plunger and it goes up and down a couple of times before saying ‘unsuccessful’ and leaves the car stuck in the air. I have to exit software before I can bring car level again.

any help appreciated.

thanks

Oct 4, 2024 | 06:14 AM

nath_h

MBWorld Fanatic!

Joined: Oct 2021

Posts: 1,206

Likes: 645

From: Iowa

2008 CL550, 2022 EQB 300, 2023 EQS 450 4Matic

Quote:

Originally Posted by dannyfiveforty

I had the same thing as you recently. The car was off, with the right front sitting low and Xentry would not successfully perform the calibration. I had to give up and take it to the dealer. They managed to calibrate it, but the right front is still sitting around 3mm low. I gave up and decided to live with it, as the struts are original, and they will have to be replaced sooner or later anyway, and the whole process will start over. I think the dealer managed to get it 'successfully' calibrated while sitting on an alignment rack.