FS mint oem Mercedes SL500 18" wheels (pics) $500
Thread Starter
Almost a Member!
Joined: Jan 2006
Posts: 38
Likes: 0
From: San Jose, CA
01 CLK430
FS mint oem Mercedes SL500 18" wheels (pics) $500
This ia an OEM set of Silver 18" rims from a 2005 SL500 Roadster. They were removed from a Brand New Car after only 100 miles to be replaced by a set of aftermarket rims. They are in NEAR PERFECT CONDITION with the only flaw being a small paint chip about 1/8" in diameter on one of the 8.5" diameter (Front Rim) spokes.
The fronts are 18x8.5 et 35 and the rears 18x9.5 et 40.
Centercaps & Lugnuts ARE NOT included.
If you have concerns about me being new, check on this site 4g61t.org under classifieds for my feedback and I can also put them on ebay under a buy it now so you can o through the ebay check out. Local pickup is fine (San Jose, CA) or I will ship. If shipped, you pay no more than $80. I'll pay anything over that, and if it is less, you will pay the lower amount. I just want to get rid of these since I decided not to use them.
I will also consider trades for narrower wheels with similar spacing.
The fronts are 18x8.5 et 35 and the rears 18x9.5 et 40.
Centercaps & Lugnuts ARE NOT included.
If you have concerns about me being new, check on this site 4g61t.org under classifieds for my feedback and I can also put them on ebay under a buy it now so you can o through the ebay check out. Local pickup is fine (San Jose, CA) or I will ship. If shipped, you pay no more than $80. I'll pay anything over that, and if it is less, you will pay the lower amount. I just want to get rid of these since I decided not to use them.
I will also consider trades for narrower wheels with similar spacing.
Last edited by rallyguy; Jan 29, 2006 at 10:22 PM.
Thread Starter
Almost a Member!
Joined: Jan 2006
Posts: 38
Likes: 0
From: San Jose, CA
01 CLK430
The fronts are perfect. The rears would be tight, but doable. I mounted these up on my 01 clk 430 and they did not rub any plastic. If you put tires on that were much wider than the rims they would probably rub on the inside. If that were the case, small 5mm spacers could be added. Here is a pic of the wheels on the car. I lowered the wheel onto the wood just enough to partially compress teh suspension.
Last edited by rallyguy; Jan 30, 2006 at 11:08 PM.
