projekt_C32

I have a set of amps for sale these are 2 JL audio amps off a car i sold recently and picked up my c32 amg.. i will no longer use them please feel free to send me an offer on either one of the amps or both they are in great condition used for less than a year and with original boxes!

Thanks
Jaime

JL Audio e4300 - JL Audio 4 Ch 300 Watt Amplifier


Rated Power (stereo):
45W RMS x 4 @ 4 ohm (12.5V);
75W RMS x 4 @ 2 ohm (12.5V)
Rated Power (bridged):
90W RMS x 2 @ 8 ohm (12.5V);
150W RMS x 2 @ 4 ohm (12.5V)
THD at Rated Power:
<0.08% @ 4 ohm (20 Hz - 20 kHz)
S/N Ratio:
>104 dB referred to rated power (A-weighted, 20 Hz ﾖ 20 kHz noise bandwidth)
Frequency Response:
10 Hz ﾖ 25 kHz (+0, -1dB)
Damping Factor:
>200 @ 4 ohm per ch. / 50 Hz,
>100 @ 2 ohm per ch. / 50 Hz
Slew Rate:
ﾱ 22V/ﾵs
Input Range:
200mV ﾖ 8V RMS
Dimensions:
13.8" x 9.25" x 2.36"

Features:
Absolute Symmetryﾙ Class AB Circuit (U.S. Patent #6,294,959)
Differential, Noise-Cancelling Input Topology:
RCA jack inputs (low-level) and multi-pin jack (high-level)
On-board Crossover:
State-variable, 12dB/octave Butterworth with continuously variable cutoff frequency selection from 50 ﾖ 200 Hz. Configurable as Low-Pass or High-Pass

Preamp Output:
Pass-through type.
Speaker output connections:
accept up to 8 AWG wire
+12V and Ground connections:
accept up to 4 AWG wire


-----------------------------------
JL Audio e1200 - JL Audio Mono 200 Watt Amplifier


Rated Power (mono):
120 W RMS x 1 @ 4 ohm (12.5V);
200 W RMS x 1 @ 2 ohm (12.5V)

THD at Rated Power: <0.08% @ 4 ohm (20 Hz -20 kHz)
S/N Ratio: >104 dB referred to rated power (A-weighted, 20 Hz ﾖ 20 kHz noise bandwidth)
Frequency Response: 10 Hz ﾖ 25 kHz (+0, -1dB)
Damping Factor: >200 @ 4 ohm / 50 Hz,
>100 @ 2 ohm / 50 Hz
Slew Rate: ﾱ 22V/ﾵs
Input Range: 200mV ﾖ 8V RMS
Dimensions: 9.8" x 9.25" x 2.36"

Features:
Absolute Symmetry Class AB Circuit (U.S. Patent #6,294,959)
Differential, Noise-Cancelling Input Topology:
RCA jack inputs (low-level) and multi-pin jack (high-level)
On-board Crossover: State-variable, 12dB/octave Butterworth with continuously variable cutoff frequency selection from 50 ﾖ 200 Hz. Configurable as Low-Pass or High-Pass

Preamp Output: Pass-through type.
Speaker output connections: accept up to 8 AWG wire
+12V and Ground connections: accept up to 4 AWG wire