CRANK POSITION SENSOR
#1
Junior Member
Thread Starter
Join Date: Mar 2010
Location: Austin Texas
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
clk 430
CRANK POSITION SENSOR
Hey does anyone have a good brand (reliable) name for a crank position sensor. I bought mine 4/26/10. and its going bad already. It has a 6 year warr. but didnt even make it 1/4 of the way to that. thanks.
#4
Junior Member
Thread Starter
Join Date: Mar 2010
Location: Austin Texas
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
clk 430
yes, just had fuel filter and flush done. It started up after 15 minutes, Ive had this problem before, just dont remember which size socket to use.
Last edited by maxxwell22; 09-18-2011 at 10:20 AM. Reason: add additional info.
#5
Junior Member
Thread Starter
Join Date: Mar 2010
Location: Austin Texas
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
clk 430
It took a 7mm. And the easiest way to get to it was to slightly bend the heat shield back a little bit, to gain access to it. it took a little over 15 minutes.
#6
Member
Join Date: Apr 2003
Location: boston
Posts: 180
Likes: 0
Received 2 Likes
on
2 Posts
02clk55///2010GLK350
use a 1/4" socket. 3/8 is too wide to slip onto bolt. I replaced 2 CPS before I had a pressure reading done on the rail and realized that it was a bad fuel pump. Replacement too all of 30 minutes.
#7
Junior Member
Thread Starter
Join Date: Mar 2010
Location: Austin Texas
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
clk 430