No reverse lights
07-28-2016, 10:20 PM
#1
Newbie
Thread Starter
Join Date: Jul 2016
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
1999 CLK 430 W208
No reverse lights
No voltage at the rear bulbs. I am checking to see if the reverse switch in the gear selector is good. Is there a way to replace/repair the switch or does the whole selector unit (202 267 0537)need to be replaced?
I am getting an open circuit at the S10/16s2 when the selector is in the reverse position. This is the bottom socket with the two gray/yellow wires in one of the connector pins and a blue/black wire in the other pin.
Voltage was not present at either pin when the unit was installed with the ignition on and the selector in "reverse"
Thanks in advance!
I am getting an open circuit at the S10/16s2 when the selector is in the reverse position. This is the bottom socket with the two gray/yellow wires in one of the connector pins and a blue/black wire in the other pin.
Voltage was not present at either pin when the unit was installed with the ignition on and the selector in "reverse"
Thanks in advance!
