Will a Fronts : 8.5x18 ET35, Rear: 9.5x18 ET35 fit H&R Springs with no Spacers?

 

Depends on the wheel style, my ET35 wheels did not clear my OEM brakes without a spacer, rears were no problem.

 

Ah!!!! Brabus Monoblocks. I've seen 1 with a 35 and one with a 40. I hate spacers...i've had bad experience with them (even H&R hubcentric ones).

 

Well, I imagine you have the same brakes on your 550 as I had on my 500 (before my BBK conversion) so I certainly don't think the ET40's would clear. You can always call them and ask, but then again, when I called the retailer for my wheels they said they would fit with no problems, they didn't fit and I've had a lot of problems.

As for the spacers, you and me both, I hate them, I'd much rather have wheels that work and fit on their own. Saying that, H&R do make a great product but it's still adding another item where I don't want one.

Let us know what you find out.

 

Yup...so is mine with "ET35".

 

If my fronts would have been ET32 they would have fit, same with yours too right?

 

et32 would be best up front

 

Called my shop and they said 32 is best. 35 works depending on options/brakes and etc. I didn't like the H&R spacers as they gave me a bad shake with my wheels..maybe it was my wheels but i rather do without spacers. I'll call brabus later this week to inquire.

 

Good stuff Amir, looking forward to following along with your results

 

Yup.......mine were barely, barely rubbing the caliper.