Bi66s

Last night I flipped up my front seat it won't flip down now and I get message lock driver seat the head test is fully down the seat is locked into place to my knowledge but the power adjustment has no response any help will be greatly appreciated

Kevwood

I presume you've tried flipping it up then back down again and listen for the audible "click"?

Bi66s

Yeah I hear the click that's why I figure it locked but the dash still says lock driver seat and the power controls are non responsive

Louie D

Check the fuse if the controls are non responsive I doubt thats it though. The set needs to be locked in place for the control to work, Check and see if something is holding it up..

Rudeney

Mine does this occasionally. Barring anything under the seat preventing it from going down fully, I usually get mine working again bay slamming it down pretty hard, and then it works for weeks. I haven't had time to look to see what's going on with the mechanism, but I suspect there's a sensor that get dirty or is misaligned. If you can get yours working at all, it's easy to take the seat's back panel off (two TORX bolts on the bottom edge, then it drops down) and you should be able to see the mechanism there.

Bi66s

i ended up moving the seat by wiring passenger side to driver side just so car was driveable still has message lock driver seat i pretty sure its locked i slammed it and it dosent move until i pull handle up

Rudeney

Yep, mine does that, too. It locks, but it doesn't trigger the sensor so the headrest stays down, the seat controls don't work, and the MFD shows the message. Slamming it in place does the trick with mine. I guess yours has a broken or disconnected sensor.