rear DTF diffuser
Thread Starter
Super Member
Joined: Jul 2014
Posts: 773
Likes: 22
From: Dallas
2013 CLS63, 2001 ML430, 2012 e350 coupe
rear DTF diffuser
Has anyone installed or purchased this rear diffuser. Really like the looks. Im curios about quality and fitment.
https://www.octanemotorsports.com/03...-p-132570.html
Thanks
https://www.octanemotorsports.com/03...-p-132570.html
Thanks
MBWorld Fanatic!




Joined: Jun 2008
Posts: 1,227
Likes: 61
From: Atlanta Metro
2008 clk550 - Navigator - Frontier
Many members have installed the VIS rear diffuser. I have one on my car. There was a group buy thread a couple years ago; I got mine through that group buy. The fitment is great; although I had to use a bit of JB-Weld on either side for the wings that curl under the rear fenders. For the rest, only the 3m tape was needed.
The quality is excellent; no bubbles or cracks that I could see (even today); uniform color and a clean (no burrs) form. It is very light and not over done with fiberglass and epoxy like many (if not most) aftermarket cf parts.
The quality is excellent; no bubbles or cracks that I could see (even today); uniform color and a clean (no burrs) form. It is very light and not over done with fiberglass and epoxy like many (if not most) aftermarket cf parts.
https://mbworld.org/forums/exterior-...-diffuser.html
always check the classified on the forum i always find great parts!
https://mbworld.org/forums/exterior-...-diffuser.html
always check the classified on the forum i always find great parts!
https://mbworld.org/forums/exterior-...-diffuser.html
Thread Starter
Super Member
Joined: Jul 2014
Posts: 773
Likes: 22
From: Dallas
2013 CLS63, 2001 ML430, 2012 e350 coupe
https://mbworld.org/forums/exterior-...-diffuser.html
always check the classified on the forum i always find great parts!
https://mbworld.org/forums/exterior-...-diffuser.html
always check the classified on the forum i always find great parts!
https://mbworld.org/forums/exterior-...-diffuser.html
Many members have installed the VIS rear diffuser. I have one on my car. There was a group buy thread a couple years ago; I got mine through that group buy. The fitment is great; although I had to use a bit of JB-Weld on either side for the wings that curl under the rear fenders. For the rest, only the 3m tape was needed.
The quality is excellent; no bubbles or cracks that I could see (even today); uniform color and a clean (no burrs) form. It is very light and not over done with fiberglass and epoxy like many (if not most) aftermarket cf parts.
The quality is excellent; no bubbles or cracks that I could see (even today); uniform color and a clean (no burrs) form. It is very light and not over done with fiberglass and epoxy like many (if not most) aftermarket cf parts.



