Changing low-beam bulbs W208 clk55
#1
Senior Member
Thread Starter
Changing low-beam bulbs W208 clk55
I feel foolish asking this but I need to change a low-beam bulb (drivers side) and cannot figure it out. The manual says...
1. Rotate cover - CHECK
2. Pull off elec connector - CHECK
3. Unhook clamping ring and remove bulb - WHAT THE?
I can tell the bulb seats into a socket. It is black and the elec connector goes into it. I see nothing resembling a clamping ring? There is an orange plastic piece with 3 screws surrounding it? If I am supposed to turn the black socket it out, I can get no leverage on it.
Any help is greatly appreciated!
1. Rotate cover - CHECK
2. Pull off elec connector - CHECK
3. Unhook clamping ring and remove bulb - WHAT THE?
I can tell the bulb seats into a socket. It is black and the elec connector goes into it. I see nothing resembling a clamping ring? There is an orange plastic piece with 3 screws surrounding it? If I am supposed to turn the black socket it out, I can get no leverage on it.
Any help is greatly appreciated!