Yet another fitment question
#1
Junior Member
Thread Starter
Yet another fitment question
20x9 20x11 35mm offset all the way around... Yay or Nay?
Found a set of stunning Rohana RFX10s in brushed titanium that were only ordered and test fitted for an Audi R8 V10 Roadster that the buyer is willing to sell very cheap... Would they fit on mine?
Found a set of stunning Rohana RFX10s in brushed titanium that were only ordered and test fitted for an Audi R8 V10 Roadster that the buyer is willing to sell very cheap... Would they fit on mine?
#2
Super Member
20x11 will be a very aggressive fitment. I can't speak with the offset numbers. The only fear is that the rear wheels/tires might stick out a little unless lowered a little. But still might not be enough? I asked a few wheel manufacturers and they refrained me from running 20x11 in the rear. Mine is lowered on 20x10.5. But after lowering it, I can barely fit a finger up against the fender and the tire gap. I don't remember my offset numbers, btw.
#4
Junior Member
Thread Starter
I didn't, I was advised by my cousin who has had 2 W218's that it would be extremely difficult to fit. I'd have to roll the fender, run an aggressive alignment and stretched tires and that's not my cup of tea.