Command screen not working
Thread Starter
Newbie
Joined: Jan 2021
Posts: 14
Likes: 3
From: Cobh Co. Cork Ireland
CLS 220 D
Command screen not working
good morning all.
I am new here so forgive me if I am not doing this right.
On Sunday last I was on a journey in my 2016 CLS 220D about 1 Hour into the journey the command screen flashed on and off about 4 times and then went blank.
it is still blank today the radio is working fine and the Bluetooth working perfectly
I would appreciate any help to rectify this matter
thank you in advance.
Bobby.
I am new here so forgive me if I am not doing this right.
On Sunday last I was on a journey in my 2016 CLS 220D about 1 Hour into the journey the command screen flashed on and off about 4 times and then went blank.
it is still blank today the radio is working fine and the Bluetooth working perfectly
I would appreciate any help to rectify this matter
thank you in advance.
Bobby.
Super Member
Joined: May 2015
Posts: 606
Likes: 88
From: North Cali
2005 SL500, 2015 CLS400
Most likely you will need someone who can read the codes / errors from the SAM units (main computers of the car). Considering everything else works it does make me think about a defective screen itself or possible defective wiring. Electrical issues hard to pin point without proper scanning.
Regards
Regards
Thread Starter
Newbie
Joined: Jan 2021
Posts: 14
Likes: 3
From: Cobh Co. Cork Ireland
CLS 220 D
Most likely you will need someone who can read the codes / errors from the SAM units (main computers of the car). Considering everything else works it does make me think about a defective screen itself or possible defective wiring. Electrical issues hard to pin point without proper scanning.
Regards
Regards
Thread Starter
Newbie
Joined: Jan 2021
Posts: 14
Likes: 3
From: Cobh Co. Cork Ireland
CLS 220 D
the good news is
when i went to remove the comand screen one of the screws was not tightened down i think this may have been a factory error
and one of the cables had slipped out
so i removed both the power and the fiber optic cables and cleaned up the area hoked back up both cables and "HEY PRESTO" the screen is working perfect again
retightened both screws and happy now
thank you all for your help and input
bobby
when i went to remove the comand screen one of the screws was not tightened down i think this may have been a factory error
and one of the cables had slipped out
so i removed both the power and the fiber optic cables and cleaned up the area hoked back up both cables and "HEY PRESTO" the screen is working perfect again
retightened both screws and happy now
thank you all for your help and input
bobby
